Your pulse rate, also called heart rate, is the number of times your heart beats per minute. This measurement is one of the most basic vital signs that doctors use to understand your overall health. When you take your pulse, you are counting heartbeats as blood is pumped through your arteries with each contraction of your heart.
Learn About Building Trust With Feral Cats →
A normal resting pulse rate for adults typically ranges between 60 and 100 beats per minute, though athletes and very fit individuals may have lower rates. Children generally have faster pulse rates than adults, with normal ranges between 70 and 100 beats per minute for school-age children and up to 140 beats per minute for infants. Your pulse rate can tell you important information about your cardiovascular health, your stress level, and how hard your body is working during physical activity.
Learning to measure your pulse by hand is a valuable skill that requires no equipment and takes only a few minutes to master. Unlike using expensive monitors or devices, manual pulse checking is something you can do anytime, anywhere. This ability allows you to track changes in your heart rate throughout the day, monitor your fitness progress, and notice unusual patterns that might warrant a conversation with your doctor.
Your pulse rate changes constantly based on many factors. When you are stressed, anxious, or sick, your heart rate increases. During sleep or deep relaxation, it slows down. After exercise, your heart rate rises significantly and then gradually returns to normal. Understanding these normal variations helps you recognize when something might be different or concerning.
Practical Takeaway: Understanding that your pulse rate is a window into your cardiovascular health helps you recognize why learning this skill matters. Knowing your typical resting pulse rate gives you a baseline to notice changes in your body.
To measure your pulse by hand, you must first find one of the pulse points on your body where an artery runs close enough to the surface of your skin that you can feel it. The two most common and easiest pulse points to locate are the radial artery in your wrist and the carotid artery in your neck. Both locations allow you to feel your heartbeat with just your fingertips.
Learn How Gift Card Activation Works Today →
The radial artery pulse point is located on the inside of your wrist, on the thumb side. To find this location, hold your hand out in front of you with your palm facing upward. Look at the inside of your wrist where you would wear a watch. This area contains the radial artery, which runs close to the surface of your skin. This is typically the most comfortable location for most people to check their pulse, especially if you are new to the technique.
The carotid artery pulse point is located on the side of your neck. To find this location, place your fingers gently on the side of your neck, between your windpipe and the large muscle running along your neck. This location has a very strong, easy-to-feel pulse. However, you should be gentle with the carotid artery and never apply too much pressure, as doing so can restrict blood flow to your brain. Many healthcare providers recommend using the wrist pulse point for routine checks and reserving the neck pulse point for situations where the wrist pulse is difficult to locate.
Other pulse points exist on your body, including the inside of your elbow, behind your knee, in your groin area, and on the top of your foot. These locations are less commonly used for routine pulse checks but can be helpful if the wrist and neck locations are not accessible. For most daily pulse monitoring, the wrist remains the preferred location due to its accessibility and ease of use.
Practical Takeaway: Practice locating both your wrist and neck pulse points several times so you can find them quickly and confidently whenever you want to check your heart rate.
Using the correct hand position and finger placement is essential for successfully locating and measuring your pulse. For the wrist pulse, extend one arm in front of you with your palm facing upward. Using the opposite hand, place your index and middle fingers (second and third fingers) on the inside of your wrist, just below the thumb. Do not use your thumb, as it has its own pulse that can create confusion and inaccurate readings.
Learn How AARP Whole Life Insurance Works and Costs →
Once you have placed your fingers on the inside of your wrist, press gently downward until you feel the pulse beneath your fingertips. You should feel a steady tapping or beating sensation. This is the radial artery carrying blood with each heartbeat. If you do not feel a pulse immediately, try moving your fingers slightly toward the thumb side of your wrist or slightly toward the pinky side. Sometimes the artery is positioned slightly differently from person to person.
For the neck pulse, place your index and middle fingers on the side of your neck, in the soft area between your windpipe and the large neck muscle called the sternocleidomastoid. Press gently inward and slightly upward until you feel the pulse. Never press on both sides of your neck at the same time, as this can restrict blood flow. If you feel a pulse on one side, you have found the carotid artery.
The key to success with both methods is using gentle pressure. Pressing too hard can actually make it more difficult to feel the pulse or can cause you to miss it entirely. If you are having trouble locating your pulse, try relaxing your body, taking a few deep breaths, and trying again. Sometimes anxiety or tension can make it harder to find. Additionally, your pulse may be easier to feel at certain times—for example, right after physical activity when your heart rate is elevated.
Practical Takeaway: Practice the finger placement technique multiple times in a relaxed state so that finding your pulse becomes automatic and requires no thought or frustration.
Once you have located your pulse, the next step is to count the number of beats per minute. You will need a timepiece that shows seconds—this could be a watch, a clock on a wall, or your smartphone. The standard method is to count your heartbeats for 60 seconds, which directly gives you your beats per minute without any additional math required. This is the most accurate approach and is what healthcare professionals typically recommend.
Learn About Finding and Renting Instruments Locally →
To count for a full minute, locate your pulse, look at your timepiece, and note the exact second when you begin counting. Count each beat you feel, saying the numbers out loud or in your head. Continue counting until 60 seconds have passed. When you reach the 60-second mark, stop counting. The total number you reached is your pulse rate in beats per minute.
Some people prefer to count for 15 seconds and then multiply by four to calculate beats per minute. This method is faster but requires mental math and may be slightly less accurate because errors get magnified when you multiply by four. For example, if you miscount by one beat in a 15-second count, your final answer could be off by four beats. Despite this limitation, the 15-second method can be useful when you just want a quick check throughout the day.
To count for 15 seconds, locate your pulse and begin counting when you see the second hand or digital timer start. Count continuously for exactly 15 seconds, then multiply your count by four. For example, if you count 18 beats in 15 seconds, your pulse rate would be 18 times four, which equals 72 beats per minute. When first learning, it may help to have another person watch the timer and tell you when to start and stop, so you can focus on counting.
Practical Takeaway: Until you become comfortable with the technique, use the 60-second count method for accuracy. As you gain experience, you can experiment with the 15-second method for quick checks throughout your day.
Your pulse rate changes based on what your body is doing and how you are feeling. Learning to measure your pulse under different conditions gives you a complete picture of your cardiovascular health and helps you understand what is normal for your body. The most useful measurement is your resting pulse rate, which is your heart rate when you are calm, still, and have not exercised recently.
Learn About Catalytic Converter Replacement →
To measure your resting pulse rate accurately, sit quietly in a comfortable position for at least five minutes before measuring. This allows your heart rate to settle into its true resting state. Your pulse should be measured in the morning before you get out of
This guide is for general information only and is not medical, financial, legal, or other professional advice. For decisions specific to your situation, consult a qualified professional. See our Editorial Policy.